Centrifugal separation technique for isolating biological T lymphocytes

Principle: When a suspension of mononuclear cells is passed through a nylon wool column, B cells, plasma cells, monocytes, and certain helper cells are selectively retained on the nylon fibers, while most T cells pass through the column. This makes it an effective method for obtaining a T-cell-enriched population.

2011-12-28


Technique for separating red blood cells using a low-speed centrifuge

Centrifuge the sample using a horizontal rotor centrifuge at 2,000 rpm for 20 minutes. After centrifugation, you will observe that the sample has separated into multiple layers: the bottom layer consists of red blood cells, the middle layer is the layered liquid, and the top layer is plasma. Between the plasma layer and the layered liquid, there is a thin, relatively dense white layer—the mononuclear cell layer.

2011-12-28


A method for separating gel-like proteins from serum using a refrigerated centrifuge

The gel-like substance formed during serum separation in a centrifuge is fibrin. After blood collection, do not centrifuge immediately; instead, you can place the sample in a 37°C water bath for a few minutes, or let it sit at room temperature for a while. If possible, use a clot-promoting tube or a separator gel tube.

2011-12-28


Centrifuge Speed Units and Calculation Formulas

The formula for centrifugal force is the same as the formula for centripetal force: F = mv²/r.

2011-12-28


Daily Precautions for Using Laboratory Centrifuges

High-speed centrifuges are commonly used in laboratories. Given their high rotational speeds, it’s crucial to prioritize safety—especially to prevent the centrifuge from shifting or moving while operating due to imbalance or aging of the tube holders. Such movement could cause the centrifuge to fall off the lab bench. Additionally, if the lid is not properly secured, centrifuge tubes might rupture from vibration, sending glass fragments flying around and potentially causing accidents. Therefore, when using a centrifuge, you must pay close attention to the following operational precautions.

2011-12-27


The role of freezing in centrifugation during experiments.

Biological activity is most vigorous at 4°C. To maintain the temperature inside the centrifuge chamber at 4°C, it is necessary to use a centrifuge equipped with a refrigeration function.

2011-12-27


Precautions to be observed during the use of high-speed refrigerated centrifuges

When the centrifuge is running, refrigeration causes moisture in the air to condense into frost inside the centrifuge chamber. After the machine is turned off, this frost melts into water. Most low-speed, high-capacity centrifuges from overseas do not have drain holes, so water gradually accumulates in the centrifuge chamber. In such cases, users should remove the rotor themselves and clear out the accumulated water. When reinstalling the rotor, be sure to secure it properly to prevent accidents.

2011-12-26


Key parameters for selecting a high-capacity, low-speed centrifuge

The large-capacity centrifuge features a variety of rotor options and is typically equipped with adaptors that fit into large-capacity centrifuge cups. As a result, it is widely favored by research laboratories to meet diverse experimental volume requirements.

2011-12-26


How to Choose a Benchtop Centrifuge for the Laboratory

Purchase parameters for medical laboratory benchtop centrifuges: Maximum speed 5000 rpm, maximum relative centrifugal force 4390×g.

2011-12-23