Centrifugal separation technique for isolating biological T lymphocytes

Release time:

2011-12-28


Overview:

Principle: When a suspension of mononuclear cells is passed through a nylon wool column, B cells, plasma cells, monocytes, and certain helper cells are selectively retained on the nylon fibers, while most T cells pass through the column. This makes it an effective method for obtaining a T-cell-enriched population.

(1) Principle: When a suspension of mixed mononuclear cells is passed through a nylon wool column, B cells, plasma cells, monocytes, and certain helper cells are selectively retained on the nylon wool fibers, while most T cells pass through the column. This makes it an effective method for obtaining a T-cell-enriched cell population.

(2) Materials and Reagents

1. Nylon fibers (Femwall Laboratories, LP-1 Leukoqak leukocyte filters).
2. Beakers, aluminum foil, funnels, disposable gloves, etc.
3. Load nylon bristle columns into a disposable syringe.
4. Take the upper layer of plasma that has undergone natural sedimentation, and after passing it through a Ficoll-Paque density gradient separation medium, collect the mononuclear cell layer located between the plasma and the separation medium.

(3) Operating Procedures

1. Cleaning and drying nylon bristles

(1) Put on disposable gloves that have been washed to remove talc powder. Place the nylon bristles (1 or 2 packs, each containing 35 g) into a beaker, add distilled water or deionized water, cover the beaker with aluminum foil, and bring the mixture to a boil for about 10 minutes.
(2) Cool to room temperature, then pour into a funnel and allow the water to drain completely.
(3) Repeat steps (1) and (2) six times.
(4) Spread the nylon bristles onto a square tray lined with gauze. After drying in a 37℃ incubator for 2–3 days, store them in a covered square tray.

2. Install nylon hair columns

(1) Take a 50 ml glass syringe, remove the plunger, and fit a section of tubing with a clamp onto the syringe’s tip.
(2) Comb the nylon bristles and fold them appropriately to match the diameter of the syringe, then fill the syringe to a volume of about 20 ml.
(3) Wrap the syringe filled with nylon bristles, along with the syringe plunger, and sterilize it by autoclaving.

3. Cell separation

(1) Secure the syringe onto the stand, pour in 37°C cell culture medium, close the valve for a certain period of time, then open the valve to drain the cell culture medium, rinse the nylon fibers several times, and finally close the valve.
(2) Dilute the cell suspension to be separated with pre-warmed culture medium to an appropriate concentration, approximately 5.00 × 10⁷ cells/ml.
(3) Pour the cell lysate into a syringe until it completely covers the nylon fiber column. Cap the syringe and incubate at 37℃ for 45 minutes to 1 hour.
(4) Open the lower outlet and slowly release the fluid (1 drop/min), collecting it into a centrifuge tube. (5) Centrifuge to obtain the desired T lymphocytes.
(6) Close the lower opening of the syringe, add 0.85% cold physiological saline into the syringe, shake it vigorously, then fit the syringe plunger onto the syringe body. Open the lower opening and forcefully expel the liquid from the syringe—this will yield B lymphocytes, plasma cells, macrophages, and other cells adhering to the nylon fibers.

(4) Precautions

1. In this separation method, a portion of T lymphocytes is often adsorbed as well. The extent of adsorption depends on the quality of the nylon wool and also on how tightly the column is packed.
2. The recovery rate of T lymphocytes using this method is approximately 20% to 30%.
3. Used nylon bristles can be recycled: Wash them with salt water, then soak them overnight in 0.1 Molar HCl, and subsequently rinse them again using the same method as before. Mononuclear cell separation technique.

(1) Iron Powder Adsorption Method

1. Materials and Reagents

(1) Iron powder or carbonyl iron powder (Atomergic chemetals), 99% purity, with particle size less than 60 µm (Goodfellow Metals).
(2) Strong magnet (horseshoe-shaped).
(3) A small rod-shaped magnet (about 1 cm long).
(4) Capillary tubes, etc.

2. Operating Instructions

(1) Weigh a certain amount of iron powder—typically 10 g—and wash it four times with 100 ml of physiological saline to remove any soluble toxic substances. When decanting the saline solution, use a strong magnet to hold the iron powder in place.
(2) Suspend iron powder in 50 ml of physiological saline. After shaking well, aliquot the suspension into 10 bottles, seal the bottle openings, and sterilize at 121℃ for 20 minutes. Immediately after removal from the sterilizer, gently shake each bottle to prevent the iron powder from clumping. Store for future use.
(3) Before use, discard the physiological saline from the bottle and add an appropriate amount of mononuclear cell suspension (3 ml to 5 ml, with a total cell count of 8 × 10⁷ cells per bottle). Incubate at 37℃ for 45 minutes, gently shaking occasionally to keep the iron powder suspended.
(4) Add a small magnet rod into the bottle to attract the iron powder as well as the cells adhering to the iron powder.
(5) Pour out the suspension—this suspension mainly consists of lymphocytes—centrifuge, and then collect the cells.
(6) Pour a certain amount of Hank’s solution into the iron powder bottle, shake vigorously, then use a strong magnet to attract the iron powder. After a few minutes, pour out the liquid.
(7) After centrifuging the liquid at 2,000 r/min, the cells at the bottom of the tube will be mononuclear cells.

(2) Glass Plate Adhesion Method: Transfer the isolated single nucleated cells onto a sterile, clean glass dish. Incubate at 37℃ for 30–40 minutes. Gently pipette up the cell suspension using a capillary pipette—these cells are lymphocytes. Rinse the dish with an appropriate amount of Hank’s solution; the resulting cell suspension is the mononuclear cell suspension.