Iran develops a new type of centrifuge and showcases achievements in its nuclear program.

Iran’s state television, citing a statement from the Iranian Atomic Energy Organization, reported that Iran has developed “fourth-generation centrifuges” made from carbon fiber. These new centrifuges boast advantages such as “faster speeds, greater fertilizer production efficiency, and smaller footprints,” and will rotate at supersonic speeds during uranium enrichment processes.

2012-02-16


Iran Announces New Generation of Domestically Produced Centrifuges

On the 15th, Fereydoun Abbasi Davani, Chairman of the Atomic Energy Organization of Iran, announced that Iran has produced a new generation of domestically developed centrifuges for uranium enrichment and began operating these advanced centrifuges at the Natanz uranium enrichment facility on the same day.

2012-02-16


High-capacity low-temperature centrifuge for bioimmunotherapy

The GMP laboratory of the Tumor Biotherapy Department is equipped with a cell separator, a high-speed refrigerated centrifuge, a biosafety cabinet, a CO2 incubator, a large-capacity low-temperature centrifuge, an autoclave, an inverted fluorescence microscope, and an ultra-low-temperature freezer at -80℃.

2012-02-14


The principle and characteristics of the centrifuge separation process

The separation processes in centrifuges generally include three types: centrifugal filtration, centrifugal sedimentation, and high-speed separation. Centrifugal filtration is commonly used to separate solid-liquid mixtures with relatively high solid content and larger particle sizes.

2012-02-14


Teaching you about the installation and maintenance of Shanghai centrifuges.

Find the proper level: Locate a small, relatively accurate spirit level. With the centrifuge lid open, check for levelness on the spindle. Adjust the level by turning the adjusting bolts located next to the four casters. Be sure that one of the feet does not hang in midair.

2012-02-09


Introduction to New Technologies from Shanghai Medical Centrifuge Manufacturers

The centrifuge operates by means of a motor that drives the rotor to spin at high speed. In the past, these motors were DC motors equipped with carbon brushes. During operation, the carbon brushes wore down, producing sparks, noise, and even vibrations. Moreover, carbon brushes had a limited lifespan, so they had to be replaced periodically before the centrifuge could resume operation.

2012-02-09


A Brief Analysis of Centrifuge Selection Technology in Shanghai

Currently, most centrifuge manufacturers in Shanghai are basically capable of producing such equipment, and they have achieved excellent results in practical applications. As for centrifuges used in refining processes such as pharmaceutical purification, these are typically low-speed centrifuges.

2012-02-08


Operating Precautions for Low-Speed High-Capacity Centrifuges

The centrifuge begins to decelerate, and its rotational speed drops to zero within the pre-set deceleration time. Press the stop button on the control panel, and the digital display will show "dedT." A few seconds later, a flashing rotational speed value will appear, indicating that the machine is now ready for the next operation.

2012-02-08


Detailed Analysis of Surge Faults in Laboratory Centrifuge Equipment

The air intake resistance of the refrigerated centrifuge is high, for example, due to a clogged filter or an obstruction at the impeller inlet. Under normal circumstances, during installation and commissioning, surge testing is performed—adjusting the pressure and current via PI tuning—and after memorization, the system avoids high- and low-pressure surges.

2012-02-05


Description of the Service Life of Centrifuge Rotors

For high-speed and low-speed centrifuge rotors, rotor life is simply specified based on service life; aluminum alloy rotors typically have a service life of 7 years.

2012-02-03


< 1...122123124...128 >