Solution to the Bearing Heating Problem in Centrifuge Motors

Whether it's an industrial centrifuge or a laboratory centrifuge, the most critical component is the drive assembly, and bearings are an essential part of this drive assembly. Typically, experienced centrifuge purchasers will ask manufacturers a series of questions about bearings when buying a centrifuge.

2013-01-14


A low-temperature, high-capacity centrifuge is used to test blood safety.

The equipment includes a rapid biochemical testing device, a rapid hemoglobin testing device, a dedicated blood-weighing scale, a specialized blood-storage refrigerator, a quick-freezing refrigerator, a low-temperature blood-storage refrigerator at -30℃, and a low-temperature high-capacity centrifuge.

2013-01-14


The Correct Installation Procedure for Laboratory Centrifuges

Centrifuge rotors are typically made of aluminum alloy. Once corroded, their strength diminishes, making them prone to accidents. Aluminum alloys are susceptible to liquid corrosion; after cleaning, they should be dried thoroughly using a hairdryer or by inverting them for a period of time. Only after confirming that they are completely dry should they be put into use.

2013-01-10


Malaysia has developed the first small-scale beam centrifuge.

This centrifuge is equipped with a color digital camera and a high-speed flash unit. The images of the equipment in operation captured by these devices can be directly stored on a computer, and real-time operational images can also be displayed on an LCD monitor in the control room.

2013-01-04


Vibration Reduction Technology for High-Speed Centrifuges Commonly Used in Laboratories

In centrifuge design, active and passive vibration reduction are typically applied simultaneously. For high-speed centrifuges, vibration reduction is generally considered in three distinct areas:

2012-12-25


Classification of Commonly Used Centrifuges in Laboratories

Based on the different rotational speeds used, centrifuges are commonly classified into two types: high-speed centrifuges and low-speed centrifuges. Centrifuges with a rotation speed of 10,000 rpm or lower are considered low-speed centrifuges, while those exceeding 10,000 rpm are classified as high-speed centrifuges. Depending on requirements for capacity and temperature control, we further divide them into large-capacity refrigerated centrifuges and high-speed refrigerated centrifuges.

2012-12-23


Basic Components and Introduction to the Centrifuge’s Rotor Chamber

The rotor chamber is one of the most fundamental components of a centrifuge. In older centrifuges, the lid of the rotor chamber is equipped with a power switch; the motor can only be started once the lid is securely closed, ensuring safety. In newer centrifuges, the rotor chamber is fitted with an electromagnetic lock that secures the top lid before the motor starts running. The lid can only be opened after the centrifugation process is complete, the rotor has come to a stable stop, and the internal pressure has been reduced to atmospheric pressure.

2012-12-17


Centrifuges have played an important role in the development of the aerospace industry.

First, centrifuges can simulate hypergravity conditions. To acclimate to the effects of high gravitational acceleration, astronauts must rely on centrifuges during training.

2012-12-14


The IAEA says Iran has basically completed the installation of uranium enrichment centrifuges.

The number of centrifuges installed at the Fordow underground uranium enrichment facility has reached 2,784, an increase of 644 from the figure reported in August. While installation of the centrifuges is essentially complete, the number of centrifuges actually put into operation has not changed significantly compared to the figure reported in August.

2012-12-11


< 1...114115116...128 >