Solution to the Bearing Heating Problem in Centrifuge Motors

Release time:

2013-01-14


Overview:

Whether it's an industrial centrifuge or a laboratory centrifuge, the most critical component is the drive assembly, and bearings are an essential part of this drive assembly. Typically, experienced centrifuge purchasers will ask manufacturers a series of questions about bearings when buying a centrifuge.

How to Resolve the Heating Issue of Centrifuge Motor Bearings – Posted by: Posted on: 2013-1-8 8:55:46 This news has been viewed 26 times.
Whether it's an industrial centrifuge or a laboratory centrifuge, the most critical component is the drive system, and bearings are an essential part of the drive system. Typically, experienced centrifuge purchasers will ask manufacturers a series of questions about bearings when buying a centrifuge.

Here, we’ll discuss several reasons for bearing overheating:

1. It could be due to overload or overloading;

2. It could be due to heat generated by mechanical friction;
However, the main issue is whether the bearings are genuine. Some users, in pursuit of lower prices, opt for low-cost bearings, which can lead to bearing overheating and even burning—resulting in serious damage.

Therefore, the first priority is to procure genuine (imported) bearings.
Centrifuges are high-speed chemical and pharmaceutical equipment. High speeds necessitate the use of high-quality bearings. Premium, authentic bearings can ensure the centrifuge operates smoothly and reliably over the long term, with a service life that can extend to more than 10 years.

Second, pay attention to maintaining proper lubrication of the machinery and use high-quality, high-temperature lithium-based grease. The quality of the lithium-based grease is another major factor contributing to bearing overheating.
Additionally, based on your detailed inspection, if mechanical friction is accompanied by noise, mechanical components show obvious wear, and bearings are loose, then the issue is likely with the bearings, and they need to be replaced.

Third, during the machining of the centrifuge’s main spindle and bearing housing, it’s crucial to ensure accurate concentricity. Under normal circumstances, people tend not to pay much attention to concentricity; however, if the spindle’s concentricity is significantly off, it can easily lead to overheating of the bearings.

Fourth, during the machining of the spindle and bearing housing, tolerances were not met, resulting in too small a clearance between the inner (or outer) race of the bearing and the balls (or rollers).

Currently, many manufacturers omit lubrication devices in order not to compromise the spindle’s strength, making it difficult for users to perform maintenance. In fact, it would be possible to design a lubrication device on the spindle that does not affect its strength.