Iran has added 3,000 new centrifuges for processing low-enriched uranium.

Iran has installed 3,000 new-model centrifuges at the Natanz facility, doubling the rate at which it can process low-enriched uranium. According to Ahmadinejad, the number of centrifuges currently operational at the Natanz site has reached 9,000.

2012-02-22


The working process of a horizontal rotor in a centrifuge.

For the operation of a centrifuge, balancing the rotor is key to achieving good separation results.

2012-02-20


Iran has loaded nuclear fuel rods into the reactor using its new centrifuge.

Iran has begun using new-generation centrifuges at its main uranium enrichment facility.

2012-02-19


Iran develops a new type of centrifuge and showcases achievements in its nuclear program.

Iran’s state television, citing a statement from the Iranian Atomic Energy Organization, reported that Iran has developed “fourth-generation centrifuges” made from carbon fiber. These new centrifuges boast advantages such as “faster speeds, greater fertilizer production efficiency, and smaller footprints,” and will rotate at supersonic speeds during uranium enrichment processes.

2012-02-16


Iran Announces New Generation of Domestically Produced Centrifuges

On the 15th, Fereydoun Abbasi Davani, Chairman of the Atomic Energy Organization of Iran, announced that Iran has produced a new generation of domestically developed centrifuges for uranium enrichment and began operating these advanced centrifuges at the Natanz uranium enrichment facility on the same day.

2012-02-16


High-capacity low-temperature centrifuge for bioimmunotherapy

The GMP laboratory of the Tumor Biotherapy Department is equipped with a cell separator, a high-speed refrigerated centrifuge, a biosafety cabinet, a CO2 incubator, a large-capacity low-temperature centrifuge, an autoclave, an inverted fluorescence microscope, and an ultra-low-temperature freezer at -80℃.

2012-02-14


The principle and characteristics of the centrifuge separation process

The separation processes in centrifuges generally include three types: centrifugal filtration, centrifugal sedimentation, and high-speed separation. Centrifugal filtration is commonly used to separate solid-liquid mixtures with relatively high solid content and larger particle sizes.

2012-02-14


Teaching you about the installation and maintenance of Shanghai centrifuges.

Find the proper level: Locate a small, relatively accurate spirit level. With the centrifuge lid open, check for levelness on the spindle. Adjust the level by turning the adjusting bolts located next to the four casters. Be sure that one of the feet does not hang in midair.

2012-02-09


Introduction to New Technologies from Shanghai Medical Centrifuge Manufacturers

The centrifuge operates by means of a motor that drives the rotor to spin at high speed. In the past, these motors were DC motors equipped with carbon brushes. During operation, the carbon brushes wore down, producing sparks, noise, and even vibrations. Moreover, carbon brushes had a limited lifespan, so they had to be replaced periodically before the centrifuge could resume operation.

2012-02-09


A Brief Analysis of Centrifuge Selection Technology in Shanghai

Currently, most centrifuge manufacturers in Shanghai are basically capable of producing such equipment, and they have achieved excellent results in practical applications. As for centrifuges used in refining processes such as pharmaceutical purification, these are typically low-speed centrifuges.

2012-02-08


< 1...121122123...127 >