Why does the lifespan of your centrifuge differ from what the manufacturer promised?
Release time:
2020-07-21
Overview:
Why is your... Centrifuge The lifespan falls short of the manufacturer’s promise.
One of the core components of a centrifuge is the bearing. If the rotor isn't properly balanced, it can damage both the machine and the operator—a basic operation that, when not performed correctly, can be downright fatal. Therefore, centrifuge operators must undergo thorough training and certification before taking up their posts.
Before loading samples into the centrifuge, it is essential to perform necessary balance checks and estimations. Finding the correct balance for your centrifuge can effectively extend its service life. In fact, during the design and manufacturing stages, centrifuges already compensate for imbalances caused by machining errors in the rotor through dynamic balancing tests. Nevertheless, it’s still advisable to strive for the best possible balance before starting the centrifugation process.
Regardless of the type of centrifuge, refrigeration is always used during operation. Due to moisture in the air, frost forms inside the centrifuge chamber, and after the machine is turned off, this frost melts into water. Most low-speed, high-capacity centrifuges manufactured abroad lack drain holes, causing water to accumulate steadily in the centrifuge chamber. In such cases, users should remove the rotor themselves and clear out the accumulated water. When reinstalling the rotor, be sure to secure it properly to prevent accidents.
In addition, centrifuge rotors are typically made of aluminum alloy. Once corroded, their strength diminishes, making them prone to accidents. Therefore, after each use of the centrifuge, it is essential to thoroughly wipe them dry or directly blow them dry with a hairdryer. Even if daily drying isn't feasible, regular cleaning and drying should still be performed on a scheduled basis. At the same time, regularly inspect test tubes for cracks and replace any that show signs of damage promptly. Otherwise, if a test tube were to break during operation, it could upset the rotor's balance during rotation, potentially leading to severe accidents such as shaft failure.
In addition to the increasing variety of rotor types, there have also been significant advancements in rotor materials and designs. The primary materials used for rotors are aluminum alloy and titanium alloy. Aluminum alloy is lightweight, high in strength, and low in cost, but it has poor corrosion resistance and limited tolerance to high temperatures. Titanium alloy, on the other hand, not only shares the advantages of aluminum alloy but also boasts superior corrosion resistance and high-temperature durability, allowing it to undergo direct high-pressure, high-temperature sterilization and operate reliably under extreme heat conditions. To reduce the motor load and increase sample capacity, many manufacturers have improved both the materials and designs of rotors, introducing rotors that are both lighter and more durable.
As the market continues to evolve and products are constantly updated, centrifuges must keep pace with these market changes and continuously refine the direction of our company’s product offerings. To achieve high-quality laboratory centrifuges that feature large capacity, high speed, high precision, low failure rates, ease of operation, and long service life, we should optimize the centrifuge’s operating speed, expand the laboratory centrifuge chamber, increase rotor density, enhance motor stability, and ensure the overall machine’s rationality.
In fact, centrifuge manufacturers have put considerable effort into research and development as well as design in order to capture market share, making these machines increasingly easy to use. However, centrifuge maintenance and upkeep still cannot be taken lightly—every tiny detail needs careful attention; otherwise, the actual lifespan of your centrifuge will fall far short of the manufacturer’s promised lifespan.