Balancing Issues Before Using a Laboratory Centrifuge

Release time:

2014-03-07


Overview:

High-speed centrifuges must use a balance to weigh and balance the weights of the tubes. The weight difference must be kept extremely small; otherwise, at best, the equipment could be damaged, and at worst, the operator could be injured.

High-speed centrifuges must use a balance to weigh and balance the weights of the tubes. The weight difference must be kept extremely small; otherwise, at best, the equipment could be damaged, and at worst, the operator could be injured.

For a low-speed centrifuge, you can simply use a separate centrifuge tube and fill it with an equal volume of water to match the mass of the sample in the original tube. Both centrifuge tubes only need to contain equal volumes of the same sample. The principle for balancing is to arrange the centrifuge tubes—each with an equal mass—symmetrically around the rotor axis in a radially symmetrical manner.

A low-speed centrifuge—probably spinning at around 2,000 to 3,000 revolutions per minute—wasn't very well balanced. On top of that, the stand beneath it wasn't particularly sturdy. As a result, during centrifugation, the vibration was quite intense, and gradually, the machine started to drift off its original position. Finally, there was a loud bang—a sound so explosive that it felt as if a heavy cabinet filled with kitchenware had been suddenly dropped onto the floor.

  

The lid was broken by the bracket.

 

As you can see from this image, the inner wall has definitely been severely deformed.
 

A photo taken from above
 
Take a side view.

 

The aluminum bracket has been deformed.

 

The inner wall of the centrifuge is already damaged.


 

Looking at the image, it was as if I could hear the desperate screams and the sound of bones breaking from the centrifuge tubes.


 
How fast and how much force would it take to squeeze half of the elastic lid off a centrifuge tube?

 
From the side, you can see that a chunk has been knocked out of the inner wall.

 
In the image, the electrolytic capacitor and the nearby black square component have come loose from their sockets under intense vibration. The electrolytic capacitor now has only one lead remaining, while the black square component next to it had over 40 leads—all of which have been cleanly severed at the base.