How to Ensure Safe Operation of Centrifuges: A Three-Pronged Foundation for Interpretation

Release time:

2019-10-23


Overview:

The safe use of centrifuges in the laboratory is a well-worn topic, yet accidents still occur from time to time. So how can we enhance the safe operation of centrifuges by starting with our own safety awareness?

  In the laboratory Centrifuge The safe use of centrifuges is a well-worn topic, yet accidents still happen from time to time. So how can we enhance the safe operation of centrifuges by starting with our own safety awareness?

  As a centrifuge technician, safely operating a centrifuge should begin with its proper installation.

  Power supply voltage: Voltage fluctuations must comply with the national standard within ±10%. Otherwise, centrifuges from certain manufacturers may fail to operate properly. If voltage fluctuations exceed this range, it is recommended to use a voltage stabilizer to ensure compliance with the power grid requirements.

  The grounding wire must be secure: The wiring of the room’s power supply must meet the required standards. In China, the power system uses a three-phase four-wire configuration. The three phases refer to the three-phase electricity used in industrial settings. When using three-phase power, the neutral wire and the ground wire must be kept separate. More importantly, whether it’s three-phase industrial power or ordinary single-phase power, the ground wire must be reliably connected to prevent electric leakage. Under no circumstances should the ground wire be connected to heating pipes or water pipes.

  The floor must be level and stable: For large centrifuges, the floor at the installation site must be firmly secured to ensure that the centrifuge rotor operates smoothly without sinking or deforming. The floor surface at the installation and fixing location should be both level and sturdy.

  Find the proper level: Locate a small, relatively accurate spirit level. With the centrifuge lid open, check for levelness on the spindle. Adjust the level by turning the adjusting bolts located next to the four casters. Be sure that the "L" foot does not become unsupported.

  After the centrifuge has been installed without any issues, the next consideration is its operation. Proper operation is crucial—besides thoroughly understanding the instructions in the centrifuge’s manual, you must also pay close attention to sample loading. The key point when loading samples is ensuring balance.

  During the design and manufacturing of centrifuges, any imbalance caused by machining errors in the rotor is corrected through dynamic balancing tests. However, every centrifuge has a specified allowable level of sample loading imbalance. To compete with other manufacturers on the maximum allowable imbalance limit, centrifuge manufacturers tend to specify relatively high values. While the centrifuge can still operate at these higher imbalance levels, the resulting unbalanced forces will suddenly impact the bearings and support structures at a frequency of n times per minute, thereby causing damage to the centrifuge. Therefore, for those expensive centrifuges, users are advised to achieve optimal balance before starting the centrifugation process—this practice will significantly extend the lifespan of the centrifuge.

  The above briefly explained the installation and operation of centrifuges. Next, let’s talk about cleaning. You might wonder: What does cleaning have to do with safe use? Actually, cleaning is essential to prevent contamination during the safe operation of the centrifuge.

  For example, when a centrifuge is running with refrigeration, moisture in the air can cause frost to form inside the centrifuge chamber. After the machine is turned off, this frost melts into water. Most low-speed, high-capacity centrifuges from overseas do not have drain holes, so water gradually accumulates in the centrifuge chamber. In such cases, users should remove the rotor themselves and clean out the accumulated water before reassembling the rotor.

  The three points mentioned above are all basic safety precautions for the routine use of centrifuges. Of course, today the centrifuge market is booming, and there’s an especially wide variety of centrifuge models available. Therefore, as a centrifuge technician, I’d like to remind you that after purchasing a centrifuge, be sure to communicate frequently with the manufacturer, ask lots of questions, and keep learning—this will definitely help you avoid unnecessary operational mistakes.