Material and Applications of Lu Xiangyi Centrifuge Rotors

Release time:

2014-06-27


Overview:

Rotors for low-speed centrifuges operating below 5,000 r/min are typically made from ordinary steel, stainless steel, and engineering plastics. Rotors for high-speed centrifuges ranging from 5,000 to 50,000 r/min, as well as those for some ultracentrifuges, are often made from aluminum alloys.

The selection of rotor materials should primarily take into account their mechanical strength and resistance to corrosion when handling the samples being processed. Rotors for low-speed centrifuges are typically made from stainless steel, ordinary steel, or even engineering plastics; whereas rotors for high-speed and ultrahigh-speed centrifuges are often made from aluminum alloys and titanium alloys.

The mechanical stress acting on the rotor is proportional to the square of the rotational speed; the higher the rotational speed, the greater the stress experienced by the rotor. This stress is centrifugal in nature and classified as a body force, which is directly proportional to the material’s density. Therefore, centrifugal rotors should be made from materials with high specific strength (strength-to-density ratio)—and for convenience in dimensional calculations, we still use density here. The primary materials with high specific strength include aluminum alloys, titanium alloys, and carbon fiber.

Aluminum alloys, titanium alloys, and carbon-fiber-reinforced plastics have already been used in rotor manufacturing. Among these, carbon-fiber-reinforced plastics are now commonly referred to as carbon-fiber composites. Glass-fiber-reinforced plastics, however, have not yet been employed. Martensitic steel is used in the manufacture of gas centrifuge rotors, such as those found in ultracentrifuges used for uranium enrichment.
Since the maximum allowable speeds and capacities of different rotors vary considerably, and considering the cost of rotor manufacturing, low-speed centrifuge rotors operating below 5,000 r/min are generally made from ordinary steel, stainless steel, and engineering plastics. High-speed centrifuge rotors—ranging from 5,000 to 50,000 r/min—and some ultrahigh-speed centrifuge rotors are often made from aluminum alloys. For speeds exceeding 50,000 r/min, titanium alloys are predominantly used. In recent years, carbon-fiber composite materials have also been employed in rotor manufacturing, though rotors made from these materials remain relatively rare and are quite expensive.