Regular maintenance of centrifuges in use

Release time:

2014-02-24


Overview:

Before use, place the centrifuge on a stable floor surface and ensure that the unit does not shake. After confirming that peripheral facilities such as the power supply are functioning properly, connect the centrifuge to the power source.

(1) Before use, place the centrifuge on a stable, level surface and ensure that the unit itself is securely fixed and does not wobble. Only connect the centrifuge to the power supply after confirming that all peripheral equipment, including the power source, is functioning properly. When loading samples, it is crucial to maintain balance, as the centrifuge generates significant centrifugal forces during operation—especially at high speeds. An unbalanced sample can produce substantial torque: in mild cases, this may cause the machine to vibrate or shake; in severe cases, it could twist the rotor shaft, leading to even greater vibrations or, worse yet, shaft breakage. After turning on the power switch, set the desired rotational speed—ideally, gradually increasing from low to high. Under no circumstances should you open the centrifuge lid while it is running. If you notice any abnormalities during operation, immediately turn off the power. Do not wait until more serious consequences occur before shutting down the machine; instead, promptly contact a medical equipment maintenance engineer. After completing the experiment, gradually reduce the speed until the centrifuge comes to a complete stop on its own, then turn off the power.


(2) Medical equipment maintenance engineers should regularly replace easily worn components such as centrifuge motors, lubricate bearings, and inspect and repair components that are prone to damage, ensuring that the equipment operates in proper condition and preventing potential problems before they occur.