The importance of analyzing specific problems on a case-by-case basis in centrifuge operation.

Release time:

2022-06-21


Overview:

As a centrifuge manufacturer, in addition to providing worry-free after-sales service that gives customers peace of mind, appropriately discussing relevant centrifuge knowledge can help a wider range of users gain a deeper understanding. Technical discussions can enable everyone to feel less anxious when using centrifuges daily and to calmly and confidently handle unexpected situations.

  As a Centrifuge manufacturer Besides worry-free after-sales service that gives customers peace of mind,

  A proper exploration of relevant centrifuge knowledge can enable a broader user base to gain a deeper understanding.

  A technical discussion can help everyone feel less anxious when using centrifuges in daily life and enable them to calmly and composedly handle unexpected situations.

  Today, we’ll focus on the following three issues:

  (1) Why do centrifuges operating at high speeds need to be frozen or evacuated?

  (2) You’ve carefully balanced the two sample centrifuge tubes, but after starting the centrifuge, an imbalance still occurs. After stopping the machine and removing the tubes to weigh them again, you find that the two tubes are still perfectly balanced. Why might this imbalance have occurred in the first place?

  (3) In general papers, some researchers report centrifugation conditions in terms of rotational speed—such as 8,000 rpm—while others specify centrifugal force—in terms of, for example, 10,000 g. What is the difference between these two approaches? Which one is more appropriate?

  To address the first question, let’s take an example: Proteins tend to lose their activity at high speeds. How can we prevent this? The answer is freezing. At high speeds, the rapid rotation of the rotor causes intense friction with the air inside the centrifuge chamber, generating significant heat that raises the sample’s temperature. To avoid protein inactivation and denaturation, we must resort to freezing. Therefore, general-purpose centrifuges should not operate at excessively high speeds. If you need higher speeds, you’ll have to use a refrigerated centrifuge. And when even higher speeds are required, you’ll also need to apply vacuum conditions.

  The second issue is balancing. When you encounter this situation, carefully follow the balancing procedure and review the process again from the beginning. This issue deserves serious attention—failure to balance properly can be very dangerous. Fortunately, modern centrifuges now come equipped with prompts to help you out.

  The final question concerns the relationship between centrifuge rotational speed (RPM) and gravitational force (g). There’s a specific formula that links these two quantities. The conversion formula between centrifugal force G and rotational speed RPM is as follows: G = 1.11 × 10^(-5) × R × (rpm)^2 Here, G represents the centrifugal force, typically expressed as a multiple of g (the acceleration due to gravity). The term 10^(-5) means 10 to the power of negative five; (rpm)^2 refers to the square of the rotational speed; and R is the radius, measured in centimeters. For example, if the centrifuge radius is 10 cm and the rotational speed is 8,000 RPM, the centrifugal force can be calculated as follows: G = 1.11 × 10^(-5) × 10 × (8,000)^2 = 7,104 Thus, the centrifugal force is 7,104 g.

  So there’s no question of “suitable” or “unsuitable”—it depends on the actual experimental requirements.

  The above is a presentation of relevant technical information about centrifuges. If you have any additional insights or comments, feel free to join the discussion!