Relevant information
Gain a deeper understanding of cells through laboratory centrifuges.
Release time:
2022-08-26
Overview:
By using a laboratory centrifuge and the differential centrifugation method, various cellular components can be separated to enable the study and identification of the nucleus and mitochondria.
Separation and purification methods:
Based on the differences in physical characteristics such as size, shape, and density of cellular organelles, centrifugation has become the most widely used technique for separating subcellular components.
Centrifugation is a method that utilizes the centrifugal force generated by rotational motion, as well as differences in the sedimentation coefficients or buoyant densities of substances, to separate, concentrate, and purify materials.
These mainly include methods such as differential centrifugation and density-gradient centrifugation.
Density gradient centrifugation:
·When there is a difference in sedimentation coefficients among particles, under a certain centrifugal force,
A method in which particles settle at their respective rates, forming bands in regions with different density gradients.
·When a gradient is prepared using sucrose solutions of two different concentrations and subjected to centrifugation, mitochondria and cellular components with sedimentation coefficients smaller than that of the gradient interface will accumulate at the interface, while cellular components with larger sedimentation coefficients will settle to the bottom of the centrifuge tube.
Detailed experimental procedure:
Preparation of animal hepatocyte homogenate:
(1) Remove the liver (about 2 g), first rinse it thoroughly with clean water, then place it in a petri dish set on ice and use scissors to cut it into small pieces. Remove any connective tissue, repeatedly wash it with physiological saline to remove as much blood contamination as possible, and blot off any surface liquid with filter paper.
(2) Add 10 mL of pre-cooled 0.25 mol/L sucrose-0.003 mol/L calcium chloride solution. (3) Transfer the suspended liver tissue suspension into a tissue homogenizer and homogenize until no visible tissue fragments remain.
(4) Transfer the liver tissue homogenate into 50 ml centrifuge tubes and centrifuge at 1500 rpm at 4°C for 2 minutes (to remove large tissue fragments).
Separate various cellular components from cell lysates using differential centrifugation:

Common media:

Common media (inert substances with high solubility): sodium chloride, sucrose, and polyethylene glycol.
Throughout the entire experimental procedure, in addition to following the prescribed operating procedures, special attention must be paid to the safe use of the centrifuge. Furthermore, as much as possible, thoroughly mince the liver tissue beforehand to shorten the homogenization time. The entire separation process should not be prolonged excessively, so as to preserve the physiological activity of the components.
Keywords: