Four factors that determine the separation performance of laboratory centrifuges

Release time:

2014-10-22


Overview:

The separation efficiency of laboratory centrifuges depends not only on factors such as the type of centrifuge and the centrifugation method, but also on crucial conditions including the centrifuge’s rotational speed, separation time, separation temperature, and the pH value of the medium solution.

The separation efficiency of laboratory centrifuges depends not only on factors such as the type of centrifuge and the centrifugation method, but also on crucial conditions including the centrifuge’s rotational speed, separation time, separation temperature, and the pH value of the medium solution.

I. Centrifuge Speed:

The magnitude of centrifugal force depends on the rotational speed of the rotor and the radius of rotation. When describing centrifugation conditions, low-speed centrifugation is typically expressed in terms of revolutions per minute (rpm) of the rotor. In high-speed centrifugation—especially ultrahigh-speed centrifugation—relative centrifugal force (RCF) is often used instead. In practical applications, the centrifugal force usually refers to the average value of the relative centrifugal force, that is, the centrifugal force at the midpoint of the centrifuge tube.

II. Separation Time:

The separation time varies depending on the centrifugation method used.

For differential centrifugation, the separation time refers to the duration it takes for particles to completely settle to the bottom of the centrifuge tube.

For rate-zonal centrifugation, the separation time refers to the duration required to form well-defined zones.

For isopycnic zone centrifugation, the separation time refers to the equilibrium time required for particles to completely reach the isopycnic point.

The factors influencing the band formation time required for rate-zonal centrifugation and the equilibration time required for isopycnic band centrifugation are quite complex and can be determined through experimentation.

III. Separation Temperature:

To prevent the aggregation, denaturation, and inactivation of separated substances, in addition to carefully selecting the centrifugation medium, it is also essential to maintain proper separation temperature—typically around 4℃. For substances with good thermal stability, centrifugation can be carried out at room temperature. During high-speed or ultrahigh-speed centrifugation, the rapid rotation of the rotor generates heat, leading to a rise in temperature; therefore, a cooling system must be employed to keep the temperature within a specified range.

4. pH of the medium solution:

The pH of the centrifugation medium solution should be within the stable pH range for the substances being separated; a buffer solution may be used if necessary. Additionally, excessively acidic or alkaline conditions can cause corrosion of the rotor and other components of the centrifuge, so such conditions should be avoided as much as possible.