Summary of issues to note when operating a centrifuge.
Release time:
2020-05-20
Overview:
Centrifuge What is the principle of centrifugal force?
When a suspension containing fine particles is left undisturbed, the particles suspended in the liquid gradually settle down under the influence of the gravitational field. The heavier the particles, the faster they sink; conversely, particles with a density lower than that of the liquid will rise to the surface. The rate at which particles move under gravity depends on their size, shape, and density, as well as on the strength of the gravitational field and the viscosity of the liquid. For example, particles about the size of red blood cells—whose diameters are on the order of several micrometers—can have their sedimentation process observed even under normal gravitational conditions.
The centrifuge is widely used in various industries such as chemical engineering, petroleum, food processing, coal mining, and water treatment—its applications are too numerous to list individually. In ancient China, people tied one end of a rope to a pottery jar, held the other end of the rope, and then rotated and swung the jar to generate centrifugal force, thereby squeezing honey out of the jar. This was an early application of the principle of centrifugal separation.
Centrifuge Cleaning method:
1. Clean the product chamber and rotor, and wipe dry any condensation inside the chamber.
2. After use, open the door until the room temperature returns to normal.
3. Equilibrate the samples before centrifugation.
4. After centrifugation, pay attention to disinfection and sterilization.
5. If necessary, precool the rotor. When maintaining and storing the rotor head, be sure to protect the counting ring at the bottom.
6. If the main power indicator light is not illuminated, check whether the indicator light’s fuse and the fuse in the indoor distribution panel have blown, and whether the power cord is making good contact. If the fuse has blown, replace it and keep the circuit open.
7. You should also check the vacuum pump gauge and the oil pressure indicator. If the oil pressure is too high, the main unit will fail to start; in that case, you need to inspect the oil lines for blockages, paying special attention to whether the throttle orifices are clear. If they’re not, you should clean them thoroughly to ensure unobstructed flow.
8. If the bearing is damaged or its rotation is obstructed, or if the bearing is lacking lubrication or has excessive dirt buildup inside, resulting in increased frictional resistance and preventing the motor from reaching its rated speed, the bearing should be promptly cleaned or replaced.
9. The surface of the rectifier is covered with a layer of oxide. Even if combustion is uneven or the brushes do not align properly with the outer edge of the rectifier, the rectifier’s rotational speed can be reduced. The commutator and brushes should be cleaned to ensure good contact.
Centrifuge What issues should we pay attention to during its operation? Based on feedback from numerous customers, the editor has summarized the key points to keep in mind when running it, hoping that these insights will be helpful to everyone’s work.
(1) When starting manually, you must first start the oil pump motor. Only after the oil pressure has reached a normal level can you start the rotary motor and the vibration motor.
(2) During operation, regularly check for any unusual noises or vibrations. If any are detected, immediately stop the machine and perform an inspection.
(3) Regularly check the lubricant level and oil pressure.
(4) Check whether the product moisture content is normal. If the moisture content is too high, inspect the incoming materials or stop the machine and check the screen basket. If machine vibration is caused by imbalance, stop the equipment, engage the safety lock, open the observation door, and check whether the screen basket is loose or if there are any accumulated residues that cannot be completely removed from the basket.
(5) Inspect the feed inlet, discharge outlet, and centrifugal liquid pipeline for any blockages. Also, check whether there is coarse particle carryover in the centrifugal liquid to assess the wear condition of the screen basket.
(6) While the centrifuge is running, product inspection samples can be safely collected. However, when taking samples through the observation port, never insert the sampler into the sieve basket.