Vibration Excitation in the Frozen Centrifuge System

Release time:

2016-07-13


Overview:

Frozen centrifuge
   Frozen centrifuge The vibration excitation in the system is caused by factors such as the motor-driven system, screen baskets and machining errors, bearings and supports, unbalanced assembled shafts, cracks and fracture cavities formed externally in the water, overheating failures, severe centrifugal forces at high speeds, and tilting of high-speed rotating shafts. When the vibration frequency exceeds the allowable limit, it can trigger resonance throughout the entire system's centrifuge, leading to serious consequences.
  Due to the centrifugal force, particles in a冷冻 centrifuge move away from the original sample layer and settle toward the bottom of the tube at different sedimentation rates. After a certain period of centrifugation, the settled particles gradually separate, eventually forming a series of distinct, discontinuous bands with clear interfaces. The larger the sedimentation coefficient, the faster the particles sink, and the lower the band will appear. Centrifugation must be terminated before the largest particles, which sediment fastest, reach the bottom of the tube. The density of the sample particles must be greater than that of the gradient medium. The gradient medium is typically a sucrose solution, whose maximum density and concentration can reach 1.28 kg/cm³ and 60%, respectively. When a suspension containing fine particles is left undisturbed in a frozen centrifuge, the gravitational field causes the suspended particles to gradually settle downward. The heavier the particle, the faster it sinks; conversely, particles with a density lower than that of the liquid will rise to the top. The rate at which particles move under gravity depends on their size, shape, and density, as well as on the strength of the gravitational field and the viscosity of the liquid. Particles on the order of red blood cell size—diameters ranging from several micrometers—can be observed undergoing sedimentation under normal gravitational conditions.
  In addition, Frozen centrifuge When a substance settles in a medium, it is accompanied by the phenomenon of diffusion. Diffusion is unconditional and absolute. The rate of diffusion is inversely proportional to the mass of the substance—thus, the smaller the particles, the more severe the diffusion. In contrast, sedimentation is relative and conditional; it requires external forces to occur. Sedimentation is directly proportional to the weight of the object—hence, the larger the particles, the faster they settle. For particles smaller than a few micrometers—such as viruses or proteins—when these particles are dispersed in a solution, they exist in a colloidal or semi-colloidal state. Under the influence of gravity alone, it is impossible to observe the sedimentation process. This is because the smaller the particles, the slower their sedimentation becomes, while the diffusion phenomenon becomes increasingly pronounced. Therefore, to force these tiny particles to overcome diffusion and undergo sedimentation, it is necessary to use a centrifuge to generate a powerful centrifugal force.
  The selection of a freeze centrifuge must be based on a comprehensive analysis of factors including the size and concentration of solid particles in the suspension (or emulsion), the density difference between solids and liquids (or between two liquids), liquid viscosity, the characteristics of the filter cake (or sediment), and the specific separation requirements. This analysis ensures that the moisture content of the filter cake (sediment) and the clarity of the filtrate (separated liquid) meet the required standards, allowing for an initial determination of the appropriate type of freeze centrifuge to use. Subsequently, for large-capacity freeze centrifuges, the choice should be further refined based on the processing capacity and the level of automation required for operation. Frozen centrifuge the type and specifications, which were ultimately verified through actual testing.