Application of Medical Centrifuges in Hospital Clinical Laboratories
Release time:
2012-10-19
Overview:
The hospital’s laboratory department uses centrifuges. When many patients go to the hospital, doctors typically draw blood samples, which are collected in vacuum blood collection tubes and then taken to the lab for testing. Observant individuals may notice that most doctors place these vacuum blood collection tubes into a centrifuge for centrifugation. The following describes the process of using a centrifuge in a hospital’s laboratory department.
First, after the doctor receives the blood collection tubes, they will place them on a rack designed for vacuum blood collection tubes. Once a sufficient number of tubes have been collected, they’ll be transferred to a centrifuge for spinning. It’s essential to use an even number of tubes, as a single tube cannot be centrifuged. During the centrifugation process, the centrifuge needs to maintain balance. Although some centrifuges are equipped with automatic balancing systems, it’s still not feasible to centrifuge just a single tube—only when the weights of the tubes are relatively close can the centrifuge operate normally. The centrifuge generates tremendous centrifugal force during operation; if the load is unbalanced, it could lead to accidents. The Shanghai Luxiangyi centrifuge is designed with protective devices that prevent it from operating normally under conditions of imbalance.
Therefore, when doctors place test tubes into the centrifuge, they always do so in a symmetrical manner. The typical setting is a duration of 5 minutes at a rotational speed of around 5,000 revolutions per second—unless otherwise specified for particular tests. After starting the centrifuge, the rotation speed gradually increases until it reaches the preset value. Once the set time has elapsed, the centrifuge will automatically stop. Due to inertia, the centrifuge’s rotation speed will slowly decrease from the set value rather than coming to an immediate halt. Thus, after the centrifuge has stopped, the door cannot be opened right away; it must wait until the centrifuge’s rotation speed has completely dropped to zero before the door can be safely opened. At the same time, the centrifuge’s current rotation speed will be highlighted on the screen. Once the speed has reached zero, the door will automatically open, allowing the doctor to remove the centrifuged blood collection tubes, place them onto a tube rack, and then send them off for further analysis.