Standard for Safely Selecting a High-Speed Refrigerated Centrifuge
Release time:
2012-08-21
Overview:
Another aspect of the mechanical safety design for centrifuges is that, in the event of the rotor “exploding” at its maximum operating speed, no fragments must be ejected outside the machine, and the cover must not be lifted open. The above points constitute the criteria for the safe selection of centrifuges.
Once the maximum rotational speed has been determined, it is also necessary to establish how many hours or cycles of operation the maximum speed can safely withstand—that is, its service life, primarily its fatigue life. No material is completely immune to permanent deformation. However, if the allowable deformation is too large, the guaranteed service life will be excessively short. Within the scope of our experiments, we conducted comparative measurements on rotors imported from abroad, and the results showed that domestically produced rotors outperformed their foreign counterparts. By the early 1990s, the safety of our rotors had already surpassed that of most foreign centrifuge manufacturers, reaching a level comparable to today’s international standards.
In the mechanical safety design of centrifuges, there are several other important aspects, among which the safety of the centrifuge chamber and its lid is paramount. Among the various rotors supplied with centrifuges, the rotor with the highest rotational speed does not pose the greatest danger in the event of an "explosion." This is because such a rotor is smaller and lighter; therefore, despite its high rotational speed, its moment of inertia is not the largest. The rotor with the highest moment of inertia at its maximum rotational speed will generate the greatest destructive force if it were to "explode" at that speed.
Another aspect of the mechanical safety design for centrifuges is that, in the event of the rotor “exploding” at its maximum operating speed, no fragments must be ejected outside the machine, and the cover must not be lifted open. The above points constitute the criteria for the safe selection of centrifuges.
In the mechanical safety design of centrifuges, there are several other important aspects, among which the safety of the centrifuge chamber and its lid is paramount. Among the various rotors supplied with centrifuges, the rotor with the highest rotational speed does not pose the greatest danger in the event of an "explosion." This is because such a rotor is smaller and lighter; therefore, despite its high rotational speed, its moment of inertia is not the largest. The rotor with the highest moment of inertia at its maximum rotational speed will generate the greatest destructive force if it were to "explode" at that speed.
Another aspect of the mechanical safety design for centrifuges is that, in the event of the rotor “exploding” at its maximum operating speed, no fragments must be ejected outside the machine, and the cover must not be lifted open. The above points constitute the criteria for the safe selection of centrifuges.