Operation and Use of Low-Speed Centrifuges
Release time:
2012-07-24
Overview:
A centrifuge is a specialized instrument that uses centrifugal force to separate and precipitate mixed liquids (containing solid particles). Commonly used laboratory electric low-speed centrifuges include low-speed, high-speed, and low- and high-speed refrigerated centrifuges, as well as various models of ultrahigh-speed analytical and preparative dual-purpose refrigerated centrifuges. Among these, low-speed centrifuges (including large-capacity centrifuges) and high-speed refrigerated centrifuges are the most widely used and are essential tools in biochemical laboratories for the separation and preparation of biomacromolecules. During experiments, filtration and centrifugation are commonly employed to separate the precipitate from the supernatant.
However, the centrifugal method works better under the following circumstances.
The precipitate is viscous, or the mother liquor is thick.
The precipitate particles are small and easily pass through filter paper.
The precipitate is excessive and loose.
The amount of precipitate is very small and needs to be quantitatively determined. Alternatively, if the volume of the mother liquor is very small, losses should be minimized during separation.
The precipitate and the mother liquor must be separated quickly.
General colloidal solution.
Basic Structure and Performance of Electric Low-Speed Centrifuges
Ordinary (non-freezing) centrifuge
These low-speed centrifuges have a relatively simple structure and can be categorized into two types: small benchtop models and floor-standing models. They are equipped with components such as a drive motor, speed regulator, and timer, making them easy to operate. The typical maximum rotational speed of a low-speed centrifuge does not exceed 4,000 rpm, while the maximum speed of a benchtop high-speed centrifuge can reach up to 18,000 rpm. Gently and smoothly turn the speed-control knob (taking about 1 to 2 minutes) until the desired speed is reached; start timing only after the speed has stabilized. Once the centrifugation is complete, slowly return the knob to the zero position.