Vibration Reduction Principles and Methods for High-Speed Centrifuges

Release time:

2012-03-02


Overview:

Vibration in high-speed centrifuges is one of the important indicators for assessing their performance.

Vibration is one of the key indicators for assessing the performance of high-speed centrifuges. Vibration reduction can be achieved through active and passive methods. Active vibration reduction involves designing the high-speed centrifuge in such a way that its operating speed is significantly offset from the critical speed of the rotating system. Passive vibration reduction, on the other hand, uses various types of vibration dampers to isolate potential vibrations from the machine frame and foundation.

1. Design the spindle bearing housing in a flexible vibration-damping configuration;

2. The spindle and the motor are connected via a flexible coupling;

3. The entire drive system is flexibly connected to the frame.

Rubber vibration dampers generally meet the vibration-damping requirements of high-speed centrifuges. Given a fixed damper structure, the higher the rubber hardness, the higher the system's critical rotational speed will be. If the hardness of the damper is too low, its strength will fail to meet the requirements and it will easily get damaged.

There are two types of shafts used in laboratory centrifuges. One type has a slender, elongated shaft that is inherently highly flexible, enabling it to automatically self-align. The other type features a thicker, shorter shaft with minimal inherent bending flexibility; however, layered vibration dampers ensure that the system’s operating speed remains above the critical speed, thus maintaining the system as a flexible one. Although both are flexible systems, the key difference between the slender flexible shaft and the relatively rigid shaft lies in how they achieve automatic alignment during operation: With the slender flexible shaft, automatic alignment primarily occurs through the shaft’s bending, allowing the rotor to rotate around its center of mass. In contrast, with the more rigid shaft, automatic alignment is achieved via the relative flexible displacements among various components within the entire rotating system.