Centrifuge Door Cover Fault Repair

Release time:

2012-01-11


Overview:

The GL21M high-speed refrigerated centrifuge is manufactured by Shanghai Luxiangyi Centrifuge Instrument Co., Ltd. This model of centrifuge has a maximum rotor speed of 21,000 revolutions per minute. During operation, the centrifuge reaches extremely high speeds; for safety reasons, it is equipped with a protective device: the machine can only operate when the door cover is closed, and the door cover can only be opened after the machine has been stopped. If the door cover cannot be opened during use, the sample cannot be removed!

  According to the available documentation, the machine’s protective device uses a manual mechanical lock. Its structure is similar to that of a conventional door lock: by pulling the handle located at the lower right corner of the door cover, the latch can be pulled out of the lock hole. Under the support of a gas spring strut, the door cover can then be opened. Since the handle and the latch are connected by an “L”-shaped metal strip—where one end of the “L”-shaped strip is attached to the handle and the other end to the latch—and both connection points are secured with screws, the reason the door cover cannot be opened is that the fixing screws have either stripped or become loose, ultimately causing the connection to come apart and preventing the latch from being pulled out of the lock hole, thus rendering the door cover unable to open.

  In such a situation, with the centrifuge power supply disconnected, you can remove the lower half panel from the front of the centrifuge (the front panel consists of two sections, upper and lower). Then, reach in with your left hand to locate roughly the position of the door lock. Use your hand to pull backward on the L-shaped metal piece. If the door cover still won't open, it means that the connection between the L-shaped metal piece and the latch end has come loose. At this point, you can use a screw approximately 5 cm long and 6 mm in diameter—turning it clockwise and slowly screwing it into the back end of the latch. After turning it in a few rotations, pull the screw backward to disengage the latch from the lock hole, thereby opening the door cover. Once the door cover is open, you can remove the door lock assembly, replace the stripped screw, reattach both ends of the L-shaped metal piece securely, and apply a small amount of lubricant to the latch and lock hole. Finally, reassemble the door lock component, and the problem will be resolved.

The above information is provided by Luxiangyi Centrifuge Co., Ltd. For inquiries about after-sales service, please call 021-68113426. http://www.lxylxj.com