Separation Experiment for Preparing Cell Membranes by Low-Speed Centrifugation
Release time:
2014-10-27
Overview:
Wash the centrifuged precipitate with a 0.25 mol/L sucrose solution, centrifuge at 1000 g (3500 rpm) for 10 min, and repeat once.
Reagents: physiological saline, 0.25 mol/L sucrose solution (containing 0.3 mol/L CaCl₂), 0.34 mol/L sucrose solution (containing 0.3 mol/L CaCl₂); Equipment: standard apparatus for isolating cell membranes.
1) Take male mice (150 g) that have been fasted for 12 hours. Decapitate them to euthanize, then bleed them. Dissect out the liver, quickly rinse it with physiological saline, and blot dry with filter paper. Take 3 g of liver tissue, mince it thoroughly, and wash it several times with cold 0.25 mol/L sucrose solution. Homogenize it in 18 ml of pre-cooled 0.25 mol/L sucrose solution, and filter the homogenate through a double-layer nylon membrane. Set aside for later use.
2) Transfer the homogenate into a centrifuge tube, carefully add an equal volume of 0.34 mol/L sucrose solution along the tube wall to cover the sample, and centrifuge at 700g for 10 minutes.
3) Wash the centrifuged pellet with a 0.25 mol/L sucrose solution, centrifuge at 1000 g (3500 rpm) for 10 min, and repeat once.
4) After centrifugation, the precipitate consists of cell nuclei, with a relatively loose upper layer above it. Carefully aspirate this upper layer and suspend it in a sucrose solution with a density of d20 = 1.16 (51 g/L). Transfer the suspension into a centrifuge tube and carefully overlay it with a sucrose solution of density d20 = 1.18 (51.5 g/L), which is added along the tube wall to cover the sample layer. Centrifuge at 700 g (3000 rpm) for 10 minutes. The cellular membrane fraction will accumulate at the interface between the two layers of solution. Carefully aspirate this fraction and store it at low temperature for further analysis.
1) Take male mice (150 g) that have been fasted for 12 hours. Decapitate them to euthanize, then bleed them. Dissect out the liver, quickly rinse it with physiological saline, and blot dry with filter paper. Take 3 g of liver tissue, mince it thoroughly, and wash it several times with cold 0.25 mol/L sucrose solution. Homogenize it in 18 ml of pre-cooled 0.25 mol/L sucrose solution, and filter the homogenate through a double-layer nylon membrane. Set aside for later use.
2) Transfer the homogenate into a centrifuge tube, carefully add an equal volume of 0.34 mol/L sucrose solution along the tube wall to cover the sample, and centrifuge at 700g for 10 minutes.
3) Wash the centrifuged pellet with a 0.25 mol/L sucrose solution, centrifuge at 1000 g (3500 rpm) for 10 min, and repeat once.
4) After centrifugation, the precipitate consists of cell nuclei, with a relatively loose upper layer above it. Carefully aspirate this upper layer and suspend it in a sucrose solution with a density of d20 = 1.16 (51 g/L). Transfer the suspension into a centrifuge tube and carefully overlay it with a sucrose solution of density d20 = 1.18 (51.5 g/L), which is added along the tube wall to cover the sample layer. Centrifuge at 700 g (3000 rpm) for 10 minutes. The cellular membrane fraction will accumulate at the interface between the two layers of solution. Carefully aspirate this fraction and store it at low temperature for further analysis.
Previous: