The application process of centrifuges in the clinical laboratory.

Release time:

2014-04-15


Overview:

During the centrifugation process, the centrifuge generates tremendous centrifugal force. If it becomes unbalanced, accidents may occur. The machine is equipped with a protective device that prevents it from operating normally under conditions of imbalance.

Many patients go to the hospital, where doctors draw blood and collect it in vacuum blood collection tubes, which are then taken to the laboratory for testing. Observant individuals may notice that most doctors place these vacuum blood collection tubes into a centrifuge for centrifugation. The following describes the process of using a centrifuge in a hospital’s laboratory.

First, after the doctor receives the blood collection tubes, they will place them on a rack for vacuum blood collection tubes. Once a sufficient number has been collected, the tubes will be transferred to a centrifuge for centrifugation. It’s essential to use an even number of tubes, because a single tube cannot be centrifuged. During centrifugation, the centrifuge needs to maintain balance. Although some centrifuges are equipped with automatic balancing systems, it’s still not feasible to centrifuge just a single tube—only when the weights of the tubes are relatively close can the centrifuge operate normally.

During the centrifugation process, the centrifuge generates tremendous centrifugal force. If it becomes unbalanced, an accident could occur. Therefore, a protective device is installed to ensure that the centrifuge cannot operate normally under unbalanced conditions.

Therefore, when doctors place test tubes into the centrifuge, they always do so in a symmetrical manner. The typical setting is a duration of 5 minutes, with a rotational speed of around 5,000 revolutions per second—unless otherwise specified for particular tests. After the centrifuge is started, its rotational speed gradually increases until it reaches the preset value. Once the preset time has elapsed, the centrifuge will automatically stop. Due to inertia, the centrifuge’s rotational speed will slowly decrease from the set value rather than coming to an immediate halt at zero.

Therefore, after the centrifuge has stopped, the door cannot be opened immediately. You must wait until the centrifuge’s speed has dropped to zero before opening the door. All medical centrifuges will prominently display the current rotational speed on the screen. Once the speed reaches zero, the door will open automatically. At this point, the physician can remove the centrifuged blood collection tubes, place them in a tube rack, and then send them for testing. If you have any questions about the specific operating procedures, please feel free to contact our after-sales department at 021-68113426.