Why do centrifuge tubes break during centrifugation?

Release time:

2014-04-03


Overview:

Therefore, when centrifuging at 3,000 rpm, we often opt for plastic centrifuge tubes. I’m not sure if your lab’s centrifuge is experiencing the same issue, but I’d recommend using plastic centrifuge tubes—and I also suggest you consider the Luxiangyi centrifuge.

Q: After filtration, I centrifuged the sample at 3,000 rpm for 15 minutes. The centrifuge tube broke—why was that? Is it related to the centrifugation speed? Could everyone please help analyze this?

 

Answer: I don’t think this has much to do with angular velocity or centrifugal force. It’s likely that when you centrifuge several tubes at once, the 2–3 centrifuge tubes placed together in a large centrifuge rotor are squeezed against each other due to the centrifugal force. Alternatively, the rubber pads inside the large centrifuge rotor may have aged and become hardened, causing them to press against the centrifuge tubes during centrifugation. My suggestion is to centrifuge your samples at 800–1000 rpm for 5 minutes—it should be sufficient to pellet the cells. Also, when inserting the centrifuge tubes into the large rotor, avoid applying too much force; just gently place them in.

 

Answer: In our experiment, we set the centrifugation time to 5 minutes. If we don’t manually stop the centrifuge, it will start accelerating after 5 minutes at the speed originally set. However, glass centrifuge tubes can withstand a maximum of 3,000 rpm; exceeding this speed easily leads to tube breakage. Therefore, when centrifuging at 3,000 rpm, we typically opt for plastic centrifuge tubes. I’m not sure whether your lab’s centrifuge experiences the same issue. I’d recommend using plastic centrifuge tubes and suggest you consider the Luxiangyi centrifuge model.