Overview of On-site Pre-treatment for Total Phosphorus in Surface Water

Release time:

2023-11-29


Overview:

Before testing, total phosphorus in surface water samples must first undergo sample preparation—this preparation process is known as on-site pretreatment. Specifically, the key indicator for raw water treatment is turbidity. Therefore, after collecting water samples, it is required to complete the raw water turbidity test immediately at the site.

  Before testing, total phosphorus in surface water samples must undergo a pretreatment process, which is referred to as on-site pretreatment. Specifically, the key indicator for raw water treatment is turbidity. Therefore, after collecting water samples, it is required to immediately perform turbidity measurements on-site. If algae are found to be accumulating, first pass the sample through a 63-micron filter mesh; then, based on the measured turbidity value, choose either natural gravity settling or centrifugation. For non-tidal river sections, when the raw water turbidity ranges between 200 and 500 NTU, use gravity settling for 60 minutes and then collect the supernatant. When the turbidity exceeds 500 NTU, employ centrifugal settling—centrifuge at 2000 rpm for 2 minutes—and then collect the upper-layer water sample. For tidal river sections, when the raw water turbidity is 200 NTU or higher, use centrifugal settling—centrifuge at 2000 rpm for 1 minute—and then collect the upper-layer water sample. The turbidimeter used must meet the relevant technical requirements. Measure the turbidity of the raw water three times, ensuring that the relative deviation among the three measurements does not exceed 5%. Use the median value as the raw water turbidity and record it accordingly.

  The steps involved in the on-site pretreatment of total phosphorus in surface water mainly include the following:

  Water quality analysis: Understanding the total phosphorus content and its distribution in water is fundamental to determining the appropriate pretreatment approach for total phosphorus.

  Select an appropriate total phosphorus pretreatment method: Based on the analysis results, chemical methods—including oxidation, extraction, and ion exchange—can be employed.

  On-site completion of raw water turbidity testing: Turbidity is a key indicator for reference in raw water treatment; therefore, it is required that the raw water turbidity be tested on-site immediately after water samples are collected.

  Filtration Treatment: If algae accumulation is observed, first use a 63-micron filter mesh.

  Select either natural gravity sedimentation or centrifugation based on the turbidity value. The specific operational steps are as follows: For non-tidal river sections, when the raw water turbidity is between 200 and 500 NTU, perform gravity sedimentation for 60 minutes and then collect the supernatant liquid; when the turbidity exceeds 500 NTU, use centrifugal sedimentation—centrifuge at 2000 rpm for 2 minutes and then collect the upper-layer water sample. For tidal river sections, when the raw water turbidity is 200 NTU or higher, use centrifugal sedimentation—centrifuge at 2000 rpm for 1 minute and then collect the upper-layer water sample.

  Determine and record the turbidity value of the raw water: The turbidimeter must meet the relevant technical requirements. Measure the turbidity of the raw water three times, ensuring that the relative deviation among the three measurements does not exceed 5%. Use the median value as the raw water turbidity measurement and record it.

  These steps are for reference only, and the specific procedures may be adjusted based on actual circumstances.

  Please note that the on-site pretreatment of total phosphorus in surface water is extremely important, as it directly affects the accuracy and reliability of subsequent total phosphorus measurements. Therefore, it is essential to follow the prescribed procedures meticulously and ensure the use of equipment and reagents that meet the required standards.

  The above information is for reference only. For more details, please refer to the relevant documents or materials on the field pretreatment of total phosphorus in surface water.


Keywords: