The centrifuge spans both the industrial and pharmaceutical sectors.

Release time:

2016-11-26


Overview:

Centrifuge
   Centrifuge It’s a highly specialized instrument that bridges the industrial and pharmaceutical sectors. In ancient times, a single term could have multiple meanings; today, a single device can serve many purposes. Of course, given the different industries involved, centrifuge models and designs vary considerably. Since both major industries find it applicable, as early as... In ancient China, people would tie one end of a rope to a pottery jar, hold the other end of the rope in their hand, and then spin the jar rapidly, generating centrifugal force that squeezed out the honey inside—this was an early application of the principle of centrifugal separation. Industrial centrifuges originated in Europe; for example, in the mid-19th century, three-legged centrifuges for dewatering textiles and suspended-type centrifuges for separating crystallized sugar in sugar mills were developed one after another. These earliest centrifuges all operated on a batch basis and relied on manual removal of sediment. Thanks to improvements in slag-discharge mechanisms, continuous-operation centrifuges emerged in the 1930s. Meanwhile, batch-operating centrifuges also saw further development as they became equipped with automatic control systems.
  There are many types of centrifuges, but their basic operating principles are consistent. The aluminum- or titanium-made rotating rotor housed in the rotor chamber is driven by a motor whose speed can be precisely controlled. Inside the rotor, there are symmetrically arranged sedimentation chambers—features that all centrifuges share. As for ultracentrifuges... Centrifuge Since the rotor rotates at an extremely high speed, friction with the air generates heat, causing the temperature of the sample being measured to change and affecting the rotor's lifespan. Therefore, the rotor chamber must be evacuated to a vacuum and equipped with a constant-temperature control system. Additionally, to prevent the high-speed rotating rotor from flying out and injuring someone, the rotor chamber is constructed as an armored steel enclosure.
  The centrifuge’s starting device (clutch) plays a crucial role. After communication and analysis, we’ve determined that the primary cause of the motor overheating in this user’s three-legged centrifuge is the third factor—because the user mentioned that the centrifuge was purchased secondhand and the starting device has never been replaced. Moreover, as soon as the centrifuge is started, the drum’s rotational speed quickly increases. Under these circumstances, we’ll have to disassemble the centrifuge and thoroughly inspect its starting device.
  The inherent characteristic of centrifugal compressors is that their surge point shifts as the speed varies. This phenomenon occurs because the discharge pressure of the compressor falls below the condenser pressure, causing backflow and thereby impacting the impeller. High-speed centrifugal compressors are particularly prone to surge—for example, single-stage centrifugal compressors from Carrier and York. Typically, surge is mitigated by means of hot-gas bypass; alternatively, it can be addressed by limiting the opening degree of the guide vanes, thus restricting the rise in condenser pressure.
  For low-speed multistage centrifugal compressors—typically operating at around 2,900 rpm—the surge point is far removed from the operating point. As a result, these units can run at as low as 10% of their rated load during operation (for example, surge in Trane’s multistage centrifugal compressors is unique to centrifugal compressors, but it applies not only to single-stage but also to multistage models). Centrifuge It will still experience surging, because at low loads the amount of air intake is small, which can cause the exhaust pressure to fall below the condensing pressure. As a result, gas backflow from the centrifugal compressor’s condenser leads to repeated cycles.