Precautions for Using a Centrifuge
Release time:
2014-01-16
Overview:
(4) When starting the centrifuge, you must first close the top cover before slowly starting it up.
Currently, centrifuges—commonly used in laboratories—are characterized by their high rotational speeds. It is crucial to pay close attention to safety, especially to prevent the centrifuge from moving while operating due to an imbalance in reagent proportions or aging of the tube holders. Such movement could cause the centrifuge to fall off the lab bench. Additionally, if the lid is left open, centrifuge tubes might rupture from vibration, sending glass fragments spinning and flying around, potentially leading to accidents. Therefore, when using a centrifuge, it is essential to observe the following operational precautions.
(1) The bottom of the centrifuge tube sleeve must be padded with cotton or a test-tube pad.
(2) If the electric centrifuge makes noise or the machine body vibrates, immediately disconnect the power supply and promptly troubleshoot the issue.
(3) Centrifuge tubes must be placed symmetrically in the rotor to prevent vibration of the machine. If there is only one sample tube, the other tube should be replaced with an equal mass of water.
(4) When starting the centrifuge, you must first close the top cover before slowly starting it up.
(5) After the separation is complete, first turn off the centrifuge. Only after the centrifuge has come to a complete stop may you open the centrifuge lid and remove the sample. Do not use external force to forcibly stop the centrifuge from rotating.
(6) The centrifugation time is generally 1 to 2 minutes; during this period, the experimenter must not leave to attend to other tasks.
(1) The bottom of the centrifuge tube sleeve must be padded with cotton or a test-tube pad.
(2) If the electric centrifuge makes noise or the machine body vibrates, immediately disconnect the power supply and promptly troubleshoot the issue.
(3) Centrifuge tubes must be placed symmetrically in the rotor to prevent vibration of the machine. If there is only one sample tube, the other tube should be replaced with an equal mass of water.
(4) When starting the centrifuge, you must first close the top cover before slowly starting it up.
(5) After the separation is complete, first turn off the centrifuge. Only after the centrifuge has come to a complete stop may you open the centrifuge lid and remove the sample. Do not use external force to forcibly stop the centrifuge from rotating.
(6) The centrifugation time is generally 1 to 2 minutes; during this period, the experimenter must not leave to attend to other tasks.
Previous: