Explosion-proof requirements for nitrogen protection of centrifuges

Release time:

2012-02-02


Overview:

The oxygen concentration inside the centrifuge during operation is monitored and subjected to quantitative control, ensuring that its oxygen content remains within a safe range.

Explosion-proof requirements

  We know that the three essential elements for an explosion are temperature, an ignition source, and oxygen. The fundamental principle underlying the prevention of chemical explosions is to ensure that these three basic conditions never coexist simultaneously. In other words, the essence of all technical measures aimed at preventing chemical explosions involving flammable substances is to prevent the simultaneous occurrence of these three basic conditions.

(1) Temperature—For a specific medium, whether in the liquid or gas phase—when designing a process, the operating temperature of the centrifuge should be taken into account. This primarily depends on the process conditions and will not be discussed in detail here.

(2) Regarding ignition sources, during centrifuge design, sufficient clearance should be provided between moving parts and the rotor pump to eliminate any potential mechanical friction or impact. Additionally, the machine must incorporate measures to dissipate static electricity. As for braking systems, mechanical friction-based brakes are prohibited; instead, electrically powered energy-consuming brakes are generally employed (non-contact brakes—though their drawback is that the braking time tends to be slightly longer than that of contact brakes, especially under full-load conditions where the moment of inertia is relatively high). Furthermore, for drive belts, antistatic belts should be selected to either eliminate or reduce the likelihood of static electricity generation.

(3) Oxygen is typically protected using an inert gas. Nitrogen is introduced into the centrifuge to displace the air inside, thereby maintaining the oxygen concentration within a safe range.

Explosion-proof measures

  The nitrogen protection system commonly used in centrifuges today actually involves merely installing a nitrogen inlet pipe and a nitrogen outlet pipe on the machine casing. During operation, nitrogen is introduced into the internal cavity of the centrifuge. However, there is no quantitative control over whether the nitrogen concentration can reach a safe level; thus, the reliability of this nitrogen protection system is quite poor. In an improved nitrogen protection system design, an online oxygen detection device and a pressure transmitter sensor are installed to continuously monitor the oxygen concentration within the centrifuge’s internal cavity during operation, enabling quantitative control and ensuring that the oxygen content remains within a safe range—i.e., keeping the oxygen concentration inside the machine below the explosion limits of flammable and explosive media.