Vibration Reduction Technology for High-Speed Centrifuges

Release time:

2012-01-26


Overview:

An elastic coupling can also be used between the rotor and the spindle. In addition to providing vibration isolation, various vibration-reducing measures help lower the critical rotational speed of the rotating system, thereby ensuring that the operating speed remains well away from the critical speed. This is why the spindles of some high-speed centrifuges are relatively thick yet not very long—yet the entire system still operates above its critical speed.

Laboratory high-speed centrifuges feature two types of shafts: one is slender and inherently highly flexible, enabling automatic alignment; the other is thicker and shorter, with minimal inherent bending deflection. Nevertheless, layered vibration dampers ensure that the system’s operating speed remains above the critical speed, thus maintaining the system’s flexibility. Although both are flexible systems, the key difference in operation between the slender flexible shaft and the relatively rigid shaft lies in how they achieve automatic alignment: for the slender flexible shaft, automatic alignment primarily relies on the shaft’s bending, allowing the rotor to rotate around its center of mass; whereas for the more rigid shaft, automatic alignment is achieved through the relative flexible displacements among various components within the entire rotating system.

  At the same time, we believe that longer, slender shafts should reasonably be made of spring steel, while shorter, thicker shafts should be made of quenched and tempered alloy steel.

  Over the long term, production experiments—and the factors we’ve encountered in after-sales service—that cause vibrations in high-speed centrifuges have proven to be numerous. Centrifuge vibration is one of the key indicators for assessing the performance quality of a centrifuge. Typically, vibration reduction can be achieved through two main approaches: active vibration reduction and passive vibration reduction. Active vibration reduction involves designing the centrifuge’s operating speed so that it significantly avoids the critical speed of the rotating system (in laboratory high-speed centrifuges, the critical speed is generally designed to be far below the operating speed). Additionally, during rotor manufacturing, dynamic balancing must be performed rigorously. Passive vibration reduction, on the other hand, uses various types of vibration dampers to isolate potential vibrations from the machine frame and foundation.

  Rubber vibration dampers generally meet the vibration-damping requirements of high-speed centrifuges. Given a fixed damper structure, the higher the rubber hardness, the higher the system's critical rotational speed will be. If the hardness of the damper is too low, its strength will fail to meet the requirements, making it prone to damage.

  In centrifuge design, active and passive vibration control are typically applied simultaneously. For high-speed centrifuges, vibration reduction is generally considered in three distinct areas:

  (1) Design the spindle bearing housing in a flexible vibration-damping configuration;

  (2) The entire drive system is flexibly connected to the frame.

  (3) The spindle is connected to the motor via a flexible coupling;

  In addition to the flexible vibration-damping design adopted for the three aforementioned components, an elastic coupling can also be used between the rotor and the spindle. Besides providing vibration isolation, these various damping measures also lower the critical speed of the rotating system, ensuring that the operating speed remains well away from the critical speed. This is precisely why some high-speed centrifuges have relatively thick but not excessively long spindles—yet the entire system still operates above its critical speed.