Operating Procedure for Renal Single-Layer Cell Culture Using a Benchtop Centrifuge

Release time:

2015-07-08


Overview:

Filter the dispersed cells through 2–3 layers of sterilized gauze. Transfer the filtrate to a benchtop centrifuge and centrifuge at 1,500 rpm for ten minutes. Discard the supernatant, add an appropriate amount of culture medium, and mix thoroughly. Centrifuge again using the benchtop centrifuge. Finally, add more culture medium to suspend the cells completely, and collect the cell suspension into a sterile Erlenmeyer flask.
  There are many methods of tissue culture, broadly categorized into suspension culture and immobilized culture. In suspension culture, minced tissue pieces are separated by centrifugation using a benchtop centrifuge. The dispersed cells obtained after centrifugation are then placed in an appropriate culture medium, where they float freely in the liquid for cultivation, after which viruses are inoculated.
 
  In addition, there is a fixed-culture method in which tissue blocks are dispersed by a benchtop centrifuge and the resulting cells are allowed to adhere to the container walls for culture. Once the cells have grown well, a virus is inoculated. The primary indicators of viral replication in tissue-cultured cells include cytopathic effects (such as cell necrosis, disintegration, and sloughing), cell fusion or inclusion body formation, and the ability of the virus to adsorb onto red blood cells.
 
  The following provides a brief introduction to the general operational techniques for “single-layer renal cell culture” using a benchtop centrifuge.
 
  1. Kidney Collection: Using sterile techniques, remove the kidneys from young animals around weaning age and place them in a sterilized petri dish. Trim off any remaining renal capsule and fat, then longitudinally cut each kidney into two halves. Remove the renal pelvis and medullary portion of each kidney. Wash the kidneys thoroughly with Hank’s solution containing double antibiotics (i.e., penicillin and streptomycin; the same applies hereafter). Transfer the kidneys to a small beaker, mince them into a milky paste, and wash again 2–3 times with Hank’s solution until the liquid becomes clear and free of blood cells.
 
  2. Digestion: Add 10 times the volume of 0.125% trypsin solution for digestion. There are two methods: hot digestion (in a 37℃ water bath) and cold digestion (in a 4℃ refrigerator). The duration of digestion varies depending on the type of tissue cells and the activity of the trypsin used, until the kidney tissue, which initially forms flocculent clumps, becomes uniformly dispersed again. Remove the trypsin by aspiration, wash the tissue several times with Hank’s solution, then add a small amount of Dulbecco’s Modified Eagle Medium (DMEM). Use a pipette to gently pipette up and down (i.e., aspirate and expel repeatedly) 10–20 times to dissociate the tissue into individual cells. Filter the dissociated cells through 2–3 layers of sterilized gauze. Transfer the filtrate to a benchtop centrifuge and centrifuge at 1500 rpm for ten minutes. Discard the supernatant, add an appropriate amount of DMEM, mix thoroughly, and centrifuge again in the benchtop centrifuge. Finally, add more DMEM to suspend the cells completely, and collect the cell suspension into a sterile Erlenmeyer flask.
 
  3. Cell Counting and Aliquoting: Take the prepared cell suspension and count the cells using a method for counting white blood cells. Based on the counting results, dilute the suspension with nutrient medium (pH 6.8–7.0) to a concentration of 500,000–600,000 cells per milliliter. Then aliquot the suspension into small flat bottles (approximately 5 ml of suspension per bottle with a capacity of about 50 ml), or alternatively, aliquot it into streptomycin vials.
 
  4. Culture: Incubate at 37℃. After 3–4 days, cells will adhere to the flask wall and form a monolayer. Thereafter, replace the maintenance medium every 3–4 days.
 
  5. Virus inoculation: Cut the diseased tissue into small pieces, add Hank’s solution containing double antibodies at a ratio of 1:4, and grind thoroughly until a milky emulsion is formed. Subject the mixture to freeze-thaw cycles to lyse the cells and release the virus fully. Use a benchtop centrifuge, set the speed to approximately 3,000 rpm, and centrifuge for 15 minutes. Transfer the supernatant into culture flasks already seeded with a monolayer of cells, allow the virus to adsorb onto the cells at 37°C for 30–60 minutes, then add maintenance medium and continue culturing.
 
  6. Harvesting the virus: Observe cytopathic effects daily or every other day under a low-magnification microscope. When 50–75% of the cells exhibit cytopathic changes, collect the culture medium from the flask and store it in a refrigerator (-20℃). This constitutes the virus stock for propagation.
 
  7. Precautions: The cleanliness of culture dishes and other utensils, the proper use of benchtop centrifuges, water quality, pH levels, and aseptic techniques—all are critical factors that determine the success or failure of tissue culture, and must be carried out in strict accordance with established requirements.