How to Meet the Special Centrifugation Requirements for Blood Banks
Release time:
2021-03-08
Overview:
Centrifuges are widely used in hospital laboratories as well as blood centers, blood banks, and blood stations in major cities.
Hospital clinical laboratories generally don't use imported centrifuges; moreover, their rotational speeds typically range from 4,000 to 5,000 rpm, and their capacities are usually between 5 and 15 ml. These are low-speed, entry-level models.
Blood banks and blood stations have relatively high requirements and need large capacities.
With the continuous increase in clinical use of blood components, blood separation has become an inevitable necessity. Currently, blood collection and supply institutions primarily rely on high-speed centrifugation to prepare whole blood into various blood components. However, during high-speed centrifugation, blood bags often suffer damage, leading to waste of precious blood resources. To effectively reduce the rate of blood wastage and minimize blood loss, special attention is paid when selecting centrifuges specifically designed for blood banks.
Of course, in addition to paying attention to your selection, you should also pay close attention to the proper usage methods. Below is information provided by Shanghai Luxiangyi Centrifuge Instrument Co., Ltd. Blood bank centrifuge Use for, provide a simple explanation:
Materials:
1. Several blood bags
2. The blood bank centrifuge features a round centrifugal rotor and is equipped with a horizontal rotor specifically designed for blood stations, capable of handling 6 × 1000 ml bags at a time and separating up to 6 five-in-one blood bags, each containing 400 ml.
Operating steps:
Step 1: Visually inspect each bag of whole blood to ensure there are no leaks and that all heat-sealed seams are intact.
Step 2: Weigh and balance the blood bag.
Step 3: Place the blood into the centrifuge rotor cup. As you fill the cup, wrap and tightly secure the catheter around the side wall. After balancing, symmetrically hang the rotor on the centrifuge stand.
Step 4: Centrifuge parameter settings: temperature 4℃, speed 3500 rpm, duration 10 min.
Step 5: After centrifugation is complete, remove the sample and place it into the collection basket, then wait for separation to occur.
Step 6: Gently place the centrifuged whole blood bag onto the plasma separation plate, transfer the upper-layer plasma into a transfer bag, and add red cell preservation solution to prepare the red cell product.

The entire process is easy and straightforward to operate. After centrifugation by the blood bank’s centrifuge, the blood bags show clearly defined layers, and throughout the entire procedure, the blood bags remain completely intact. The centrifugation results are immediately obvious at a glance.