Low-speed, high-capacity centrifugation technology for separating immune cells
Release time:
2014-03-21
Overview:
I. Immune Cell Isolation Technology
1. Isolation of lymphocytes
Take 1 mL of heparin-anticoagulated blood and dilute it with 1 mL of Hanks’ solution. Then, carefully layer the diluted blood along the wall of a test tube containing 2 mL of lymphocyte separation medium (being careful not to mix it with the separation medium). Subsequently, centrifuge at 2000 rpm for 20 minutes in a horizontal position. The tube will then separate into four distinct layers, from top to bottom: plasma, mononuclear cells, granulocytes, and red blood cells (Figure 2-1). Using a capillary pipette, extend it into the mononuclear cell layer (located at the interface between the separation medium and the plasma), and gently aspirate all the cells along the tube wall. Next, wash the cells twice with Hanks’ solution, each time centrifuging at 2000 rpm for 10 minutes. Finally, resuspend the cells in RPMI 1640 culture medium to prepare a cell suspension at a concentration of 2 × 10^6 cells/mL for further use.
2. Isolation of T cells and B cells
Pass the lymphocyte suspension through a nylon wool column. B cells will adhere to the nylon wool, while T cells will not. First, elute the nylon wool column using RPMI 1640 medium; the resulting cell suspension will be rich in T cells. Next, vigorously and repeatedly squeeze the nylon column to release the B cells that have adhered to the nylon wool, and then elute these B cells using a small volume of RPMI 1640 medium. The resulting cell suspension will be rich in B cells. The length of the nylon column (plastic tube) and the amount of nylon wool used depend on the quantity of cells to be isolated.

3. Isolation of CD4 cells and CD8 cells
(1) Isolation of CD4 cells: A certain amount of T-cell suspension is passed through a SephDex C-10 column, followed by washing with a small volume of RPMI 1640 medium. The resulting cell suspension contains approximately 85% CD4 cells.
(2) CD8 Cell Isolation: Coat the surface of a petri dish with goat anti-mouse IgG diluted in Tris buffer (concentration: 10 μg/mL), then incubate at 4°C overnight. Wash off any unbound antibody using PBS. Next, add 3 mL of T cells labeled with anti-CD8 monoclonal antibody (cell concentration: 1 × 10^7/mL) to the coated petri dish, and incubate at 4°C for 2 hours. Gently wash away any non-adherent cells using PBS, then resuspend the detached cells in 10 mL of PBS using a pipette. After washing, the collected detached cells can be suspended in RPMI 1640 medium for further use. CD4 cells can also be isolated using this method.
4. Isolation of mononuclear macrophages
Mononuclear macrophages have the property of adhering to plastic or glass surfaces, whereas lymphocytes do not possess this property. This difference allows us to separate these two cell types. The procedure is briefly described as follows: Add the cell suspension to be separated (e.g., peritoneal fluid from live animals) into a plastic or glass dish of appropriate size, and incubate it in a 37°C CO2 incubator for 1 hour. Then, gently rinse the surface of the dish with RPMI 1640 medium to remove non-adherent cells. Next, lightly scrub the surface of the dish that has retained adherent cells using the same medium, and collect the adherent mononuclear macrophages. If higher purity mononuclear macrophages are desired, the above procedure can be repeated.
II. Subculture of Tumor Cell Lines
Passaged cells refer to cells derived from human or animal tumor tissues or normal tissues, whose karyotypes have evolved into aneuploidy or exhibit a diploid content below 75%. These aneuploid cells possess unlimited proliferative potential in vitro and typically demonstrate the ability to undergo xenotransplantation as well as a broader spectrum of viral susceptibility. The key characteristics of passaged cells are: ① They exhibit consistent proliferative properties; even a small number of cells can proliferate and form clones in agar. Some grow adherent to surfaces, while others grow in suspension. ② Their karyotypes are aneuploid; most human-derived cells have approximately 60–70 chromosomes. ③ They retain species-specific features but lose tissue differentiation and organ-specific characteristics. ④ They possess oncogenic potential. Due to their rapid proliferation, ease of acquisition, and convenient storage, passaged cells have been widely adopted by laboratories worldwide.
1. Subculture of HeLa cells
Reagents and Instruments
●HeLa cells.
● Hanks’ solution, 0.25% trypsin, 0.02% EDTA, growth medium, penicillin-streptomycin (PS), 5.6% NaHCO3
● Small Erlenmeyer flasks, culture flasks, sterile pipettes (5 ml and 1 ml), droppers, waste liquid bottles, etc.
Methods and Steps
(1) Select one flask of well-growing HeLa cells. Gently shake the flask several times to suspend any debris floating on the cell surface, then discard the cells along with the growth medium. Wash once with Hanks’ solution.
(2) Add 4–5 ml of 0.25% trypsin solution or trypsin-EDTA digestion solution from the cell-free side, then invert the culture flask to ensure the digestion solution covers the cells for about 1 minute.
(3) Invert the culture flask and let it sit for 5–10 minutes. To facilitate cell detachment, you can add pre-warmed digestion solution at 37℃. Alternatively, with the cells facing upward, gently press the palm of your hand against the outer wall of the flask directly over the cell surface until you observe fine, mesh-like pores appearing on the cell surface under visual inspection.
(4) Discard the digestion solution. If EDTA-based digestion was used, add 4.5 ml of Hanks’ solution to the opposite side of the cell layer and gently rotate the culture flask during washing to allow the liquid to flow slowly throughout the flask, thereby removing the digestion solution. If trypsin-based digestion was used, no washing is required after discarding the trypsin.
(5) Add an appropriate amount of freshly prepared growth medium along the cell surface to wash off the cells, then gently pipette several times to disperse the cells evenly. Subculture the cells at a ratio of 1:2 or 1:3.
(6) Incubate at 37℃. About 30 minutes after inoculation, the cells should adhere to the culture surface. The growth medium can be replaced after 48 hours. Typically, a monolayer forms within 3–4 days. After a monolayer has formed, switch to a maintenance medium for experimental use.
Previous: