How to install a medical centrifuge? How to install a medical centrifuge? For those who have just contacted the medical centrifuge, the problem of the installation of the medical centrifuge is obviously very important, so now we will help friends to answer questions about the installation of the medical centrifuge.
First, the power supply voltage
Voltage fluctuations must meet national standards within +10%, otherwise some manufacturers' centrifuges will not function properly. If the voltage fluctuates above this, it is recommended to use a voltage regulator to comply with this grid.
Second, the ground line must be strong
The wiring of the power supply of the room should meet the requirements. China's three-phase four-wire system is three-phase in industrial power. When three-phase electricity is used, the neutral line is separated from the ground line. More importantly, it is three-phase industrial power. The general single-phase electricity is also good, the ground wire should be reliable, so as to avoid leakage, the ground wire can not be connected to the heating pipe and the water pipe.
Third, the ground should be flat and firm
For large centrifuges, it is necessary to move the floor at the installation site to ensure that the rotor of the centrifuge works normally and does not sink into the recess. The ground at the installation and fixing site should be flat and firm.
Fourth, find a good level
Find a more accurate small level, open the lid of the centrifuge, find the level on the spindle, and adjust the screwing of the adjusting bolts next to the four casters to find the level. Note that one of the feet cannot be lost.


